Gettinc sketch for mac software 10.12 mac os x#

Mac OS Yosemite (10.10), Mavericks (10.9), Mountain Lion (10.8), Lion (10.7), and presumably earlier:ĭownload and install the appropriate drivers for your version of Mac OS from the FTDI drivers website. Sudo mv AppleUSBFTDI.kext AppleUSBFTDI.disabledĪfter completing this step, continue to follow the instructions immediately below for all Mac OS versions 10.10 and below.

(We found these here.)Ĭd /System/Library/Extensions/IOUSBFamily.kext/Contents/PlugIns Open up a terminal window, then issue theįollowing commands. Mac OS Yosemite (10.10) or Mavericks (10.9):Īrduino drivers already installed, but they don't work. Nothing additional is needed you should be able to skip completely to the

Gettinc sketch for mac software 10.12 mac os x#

Mac OS High Sierra (10.13), Mac OS Sierra (10.12) or Mac OS X El Capitan (10.11): Then, follow the specific directions below depending on which version of Mac OS you are running. If this happens, click 'Open Security Preferences,' then click the 'Allow' button.

Depending on your version of MacOS, you might be told that you have to open your security preferences to grant permission to these drivers. Then click through the install agreeing to things as asked.

If you are running an older version of MacOS, open the folder titled 'Legacy MacVCP Driver,' then double click on the file 'Silicon Labs VCP Driver.pkg' contained in that folder.

If you are running 10.11 or higher (El Capitan, Sierra, High Sierra), double click on the file 'Silicon Labs VCP Driver.pkg.'.

After asking you to agree once or twice, it will pop up the contents of the dmg folder. Download the file, open it (which unzips it), and open the dmg within. Visit the Silicon Labs website, scroll down to find the section that says 'Download for Macintosh OSX,' and click where it says 'Download VCP'. Mac OS: First, for all versions of Mac OS: Installing Arduino software can be a little idiosyncratic depending on